Having a grease trap makes it possible for you to separate the oils, greases, and sludge from the water to trap them in a different compartment. These substances will pass through a system that catches them and allows them to sit and cool off and solidify. In order for the system to work regularly, though, it needs to be maintained regularly. The job is very easy, but reading through these steps will make it much easier for you and safer for the grease trap. If in doubt, you can always hire someone for grease trap cleaning in Raleigh.
Remove the lid from the grease trap very gently using a pry bar. Make sure that you go slowly so that you don’t damage any of the gaskets located under the cover. Take a good look at every piece involved with the grease trap. Because you are removing almost every piece of the system, you will need to know exactly where to put everything once it is cleaned. You can draw a diagram or you can take a picture.
In order to determine how much grease and oil is in the trap, simply take a wooden dowel or some kind of measuring stick and guide it to the bottom. This will create a mark on the wooden dowel to show you how much debris there really is. Remove all of the waste and debris in the trap into a small container or bucket. Just scoop it out with any kind of utensil and get it into the bucket. Place the debris and waste into some kind of water-tight container.
Clean out the trap as much as possible. Use soap and water on all surfaces to get rid of all of the waste that you can. Clean the lids, sides, and even the small parts with warm water and soap. Once the system is clean, just put it back together and you are good to go. If you are uncomfortable completing any of these tasks, you can always hire a professional for grease trap cleaning in Raleigh.